Weak Electrical Signal Measurement Tool 1x/10x/100x Signal Measurement Tool Battery Powered Low Noise for Maintenance Personnel

10M Bandwidth Oscilloscope Battery Powered Oscilloscope Accessories Low Noise for Maintenance Personnel for Electronic Engineers
Feature:
1. Optional Magnification: Signals Amplifier supports differential input and single-ended input, with a wide input voltage range and a maximum of+/- 10V. 1x/10x/100x selectable magnification, up to 10M bandwidth.
2. Variety of Charging Methods: The Signal Measurement Tool can be powered by batteries, and supports USB and TYPE C interface charging.
3. Ultra-low Noise: The Weak Electrical Signal Measurement Tool has ultra-low noise, high common-mode rejection ratio and long battery life.
4. Material: 10M Bandwidth Oscilloscope exquisite metal shell, strong anti-interference ability.
5. Versatile: Weak Signal Amplifier is widely applicable in the academic experiment, electronic product design,debugging and maintenance, electronic engineering education, etc.

Specification:
Origin: Mainland China
Oscilloscope Parts & Accessories Type: Oscilloscope Parts
Single-end input voltage: – 10V to+10V
Differential input voltage: – 10V to+10V
Single-end input impedance: 2M
Differential input impedance: 4M
Output voltage: – 10V to+10V
Magnification: 1x/10x/100x
Bandwidth:
G=1-10M
G=10-10M
G=100-2M
Common mode rejection ratio:>80DB
Noise: 5nV/ 1KHz
Power supply: built-in rechargeable lithium battery
Charging interface: USB TYPEC
Battery life: about 5 hours
Operating temperature: 0 °C-40 °C
Working humidity: ≤ 90% RH
Power consumption: ≤ 0.2W
Volume: 115 * 50.5 * 21mm/4.5*1.9*0.8in

Note:
This product is specially designed for amplifying weak signals. For weak current, the noise is small, the accuracy is high, and the original signal is well recovered.
The oscilloscope is usually unable to measure small signals, and the instrument needs to be amplified before measurement.
It can also be used for industrial automation measurement and control because the sensor signal is very weak and needs to be amplified before output.
This product is not a high pressure probe. The high pressure probe is used for high pressure operation. For strong current, it is generally used to measure high voltage, and the accuracy requirement is not high.
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.

1 x 10M Bandwidth Signal Amplifier
1 x 0.5m BNC straight cable
1 x BNC short-circuit cap